FW3A, a TLF/BLF EDC flashlight - SST-20 available, coupon codes public

[Mr.Scott]

@ToyKeeper

Yeah, the white O-ring by the clip is there to keep the clip from spinning freely. It’s not for the inner tube.

Something else which might help is to take out the driver retaining ring entirely, wiggle the driver around to make sure it goes into the slot it’s meant to be in, and then tighten the ring again. One edge of the driver is flat, so it can only go in one direction. Be careful not to twist the wires off though. Without de-soldering the wires, the driver can only move a little bit.

Good idea. I previously tightened the driver retaining ring, but I didn’t think to check that the flat spot on the driver was aligned with the tube.

Re: white o-ring. My first thought was that it was to keep the clip tight. But then I noted in CRX’s review that the o-ring was around the inner tube.

It seems I have a white o-ring around my inner tube too and between the clip and the body.