Help. Drivers ed. needed.

Ok I am looking for a replacement for this driver. it's 32mm and driving 6 T6's. There is only 1inch/25mm under it for room.

What I'm looking for is something that will drive 6 XM-L2's at least 2.5amps each preferably more. I would prefer to save this driver, I want to use it and the 6 T6's to make a lantern.

So I need either a good 32mm driver or a 32mm board. Any ideas?

How about this?

Smaller in diameter, but Im sure you could fashion a contact board from a bit of plastic

Thanks, that looks pretty good. I bet I could make a holder of some kind for it. This does have a retaining ring that screws down over this driver, it’s not soldered in or anything.