High current drivers for single XM-L2

[moderator007]

@Ouchyfoot

I also got one of these 3.0A Drivers from Lightmalls. It appears to be the exact same driver, minus the contact board. I’ll try a resistor mod on it also. It has a built on battery contact. It would sure make a small profile 5.0A driver.

I don’t think it will stand the heat generated at 5amps without some good heat sinking.

2 Li-ion 3 amp Driver Super Output Current Mod "Now with Larger Toroid driving a MT-G2"

This 3 amp 2 li-ion driver is from lightmalls, http://www.lightmalls.com/super-output-ssc-p7-led-driver-board-low-high-middle-5-5v-15v-2, it can be modified by changing the sense resistor value for more or less current. From the current readings I got, I’am assuming sense resistor formula is this .3 divided by total resistance (.1 ohms) equals output current (3 amps). The driver uses 2 R200 (.2 ohm) resistors wired parallel for current sense. I added a 1 ohm resistor and got 3.275 amps to the le…