I just bridged this R2 on an East-092 driver

nottawhackjob · April 9, 2013, 6:58am

I accidently knocked the R2 off per this Fasttech pic. The R2 sits next to C1. Couldn’t find it to put it back on so I went ahead and solder bridged.

The driver/led and lumen output now works just like it did before, including all modes.

Does anyone know what I’ve done by omitting the R2 resistor and bridging the gap?

nottawhackjob · April 9, 2013, 3:01pm

And if it still works then who cares! lol

dthrckt · April 9, 2013, 3:05pm

is the current on each mode the same?

nottawhackjob · April 10, 2013, 5:02am

No change in current that I can tell with my equipment.