MTN-11DD Firmware for Tool AAA with e-switch...????

[drillbitz11]

I’m working on an emitter and driver swap on a brass Lumintop tool AAA. It’s the one that came from Drop with an e-switch. The 219c emitter it came with is on the green side also so I thought it would be a good candidate for an SW40 219b and a MTN-11DD. I’m just not sure if I need to use specific e-switch firmware or if I can use Clicky firmware like MTN Standard or Guppydrv. I’m guessing that it needs to be e-switch firmware on the mcu but I just want to be sure. Thx in advance.

[jon_slider]

CRX posts more about that here:

Lumintop Tool Ti - Mods

Received my Lumintop Ti Tool yesterday, even cuter than i thought it would be . A very nice little light except it is designed for AAA use only so very underpowered for me. The problem is the switch components, when a li-ion cell is installed the light is single mode only but the driver sequences through the three modes when not using the electronic switch so i decided to install a small forward clicky switch instead of the electronic switch to remedy this and also the excessive…

maybe post a question to his thread…

[drillbitz11]

Thanks will do