Perhaps a different mod!

Hello All,
I hope anyone that is reading is well and happy new year. I have been reading quite a bit on this forum as of late. I do hope I am not out of place by proposing some questions that might help me!
I actually work as a photographer in the uk. I live in london. A lot of the lights I use for my photographs these days are led flashlights. I have quite a colection of fenix pd35’s , and some Fenix LD60’s
I have been reading a bit about the cree XHP led’s and was hoping that someone might be able to advise!
In addition to my flashlights I have a light that i use that is actually a strobe/flashlight made by a brand named profoto. It also features a 20w led “modelling” bulb so that i can see where the flash might project, it seems to be a cree CXA2530
here are my questions, and please do forgive me for asking questions that might seem obvious or stupid. I really am here to learn! Thank you so much for your help and advice it really would be greatly appreciated.

1: If I replace this with an xhp70.2 led and do not adjust the drivers/volts/amps am I right in saying it will be brighter as it has improved efficiency.?

2: If i wanted this light to give me even more lumens than it currently offers could I potentially change resistors/drivers or something like this to give the led more watts?
I am aware that the light itself has a 16v power supply.

3: Is there anyone in the uk that might be interested in making this second part a project or able to point me in the direction of someone that might be qualified enough to assist in doing it for me. I’m not entirely sure how much a project like this would cost/ how much to expect to pay?

Thank you and I really appreciate the help.

  1. You are incorrect. The CXA2530 is a 37V COB array, whereas the XHP70.2 is either 6V or 12V. Something bad will happen to your LED.
  2. You could try driving the emitter harder, I'm not familiar with it enough to know what would happen.
  3. What is the model of the actual light? It might be possible for someone to research it and help provide a jumping-off point.

ah ok!
So I guess I need to figure out what the Led on it is perhaps I am incorrect in my assumptions of what it is.
It’s a profoto b1 light
Could I use a voltmeter to establish how many Volts the LED is receiving?
I will try to find out some other way also

The led portion is about 2cm in diameter and the panel is 2.5.
The unit says it’s input is 16v but I don’t know if that is relating to the input the led is receiving