where to put a bleeder on led4power LD-A4 driver ?

[pinkpanda3310 (Pinky)]

I’m sure this question has been asked before but i can’t find the answer. Any help appreciated

[thefreeman]

Led4power.com : LD-4 CC linear drivers, ILC-0/1 illuminated tailcaps, optics, MOSX, copper DTP MCPCBs...

LD-x4 doesn't use resistor for bleeder but small jfet transistor 2SK3796 (you will see 3-pin empty space for it on driver - if you ordered one without bleeder option), parasitic current consumption during driver ON time is significantly lower compared to resistor (1mA vs 6-20mA). But adding ~300Ohm resistor between driver spring pad and gnd ring would work too.

[Unheard]

Isn’t it the topmost FET?

Edit: Oops, seems to not show up here. It’s the first picture on the product page.

[raccoon]

[Unheard]

We’ve got a clown.

[pinkpanda3310 (Pinky)]

@thefreeman

Led4power.com : LD-4 CC linear drivers, ILC-0/1 illuminated tailcaps, optics, MOSX, copper DTP MCPCBs... - #942 by led4power

Doh! Looks like I’ll be ordering parts. Thanks for the info