Recoil Laser Searchlight Build - XR10 [WIP]

Yeah that intensity diagram does seem a bit unrealistic haha but I guess we will find out soon!

My previous experience with a recoil reflector was that it was actually not that hard to focus when aiming for “focus at infinity” or perfectly collimated using my paper and hole method.
You can see this effect pictured here in my focusing guide: Light collimation with an LED flashlight
As the distance grows so does the projection of the light emitting surface (LES) so if you’re off by a fraction of a degree from perfectly parallel you still end up measuring the same intensity with a luxmeter, because everything is overlapping at far enough distance.
Obviously this is much easier with a lens since you have a nice front-facing LED even at the edge of the optic, while a recoil reflector would only capture a sliver of the LED at higher incident angles.
This reflector I picked for this build doesn’t capture as wide of an angle as my last build, and the focal length is longer, so both of those factors will make focusing easier.

Actually the main issue I had with the previous reflector was that tubing and wires would touch the side of it and push on the edge, which caused the parabola to deform and not focus properly on the LED. Electroformed reflectors are pretty bendy.
I am hoping that the glass construction of this new reflector completely solves that, it should be as rigid as a lens.

The main benefit of single crystal phosphors is that they have excellent thermal properties, being a single crystal, so you can pump lots of laser light into them without burning it up.
Powdered phosphors also require some silicone or other medium to hold the powder together, which also makes them more likely to burn under high laser power.
Ceramic phosphors are better but not as good as a single crystal from the research papers I have read.
The down side of a single crystal phosphor is the cost, which can be hundreds of dollars for something just a few mm in size.

If you couldn’t tell already I am an engineer haha
I make enough money to spend on my hobbies from time to time :slight_smile: but I hope to commercialize some of my ideas in the future as well.

2 Thanks