Can the peg holes be slotted to the edge of the board for use with the khatod 24/35 mm quad optics or are there traces outside of the optic peg holes? DIY option, of course.
Any update? I’m excited about the quad.
yes they are almost made hoping for a shipping number anytime
Cheers
MARK
Excellent! I’m almost out of Dsche’s mcpcbs.
I still have 3
edit: I should go to bed :-/
I have but one.
20mm quad XML/XHP50? what optics would you use?
Cheers
Mark
I’m guessing dedomed with Carclo quad optics.
Central hole size on quad?
3.2mm
Cheers
Mark
Ok Guys, this is the final iteration of the quad TPAD
Slotted holes verses drilled, we discussed with Carclo on this to ensure the design and with slots you can likely use khatods
This will be available in
XPG,XPE,NVSL,XTE, C35 Semileds Violet, XHP35,XPL
I will put some preorder options up this week or check with Richard at Mountain on what you need
Cheers
Mark
That’s great! Khatod has both a quad 25 mm and 35 mm that use the same footprint as the Carclo quad but with slightly wider peg locations and deeper optic so this more than doubles the possible optics you can use. Hope you can send him some bare boards as well.
That’s great! Khatod has both a quad 25 mm and 35 mm that use the same footprint as the Carclo quad but with slightly wider peg locations and deeper optic so this more than doubles the possible optics you can use. Hope you can send him some bare boards as well.
He was planning of buying a bunch of bare boards, I emailed him re this update, so hope to have it all in place
Cheers
Mark
Thanks Mark, can’t wait!
just arrived, tasty as they look
enjoy
WTF? They are not round? What is max dimention?
19.82 mmm they would look rounder if the optic holes were not slotted
Cheers
Mark
This is for XML?
No, xp size or nichia.
There is no such optics for xml.